ZTW 12amp ESC (May ship with Thurnigy 12amp ESC if ZTW 12amp is not available) ($15.99)
$65.97
$63.97
Combo 2: Save $3.00
Standard Kit ($34.99)
Turnigy 2204-14T 1450kv Motor ($14.99)
ZTW 12amp ESC (May ship with Thurnigy 12amp ESC if ZTW 12amp is not available) ($15.99)
Sieg Power 360mAh 2S 7.4V 35C Lipoly Pack ($7.99)
$73.96
$70.96
Combo 3: Save $4.00
Standard Kit ($34.99)
Turnigy 2204-14T 1450kv Motor ($14.99)
ZTW 12amp ESC (May ship with Thurnigy 12amp ESC if ZTW 12amp is not available) ($15.99)
Sieg Power 360mAh 3S 11.1V 35C Lipoly Pack ($11.99)
$77.96
$73.96
Click each photo for larger image
about 28" sbach 342 3mm depron 3d plane:
This Depron Foamie is great for light wind days in the frontyard, backyard, parking lot, or indoor gym. There are some key features that set this kit apart from other Depron kits in this class. Mainly, like it’s big brother this plane uses front fuselage doublers that give this foamie extraordinary durability in the front for those occasional hard landings with very little added weight. While other features like all precut carbon fiber and full hardware make this kit quick and easy to assemble. This plane can keep up with the best of the 3D foamies in this class, and it has great performance and great looks!
Warning! This aircraft is not a toy. If built or flown incorrectly, this plane can cause damage property or injury to people. User assumes all responsibilty and risk. It should be flown only in fields specifically reserved for RC aircraft which have been approved by the AMA. It is highly recommended that you join the AMA if you are not already a member.
specifications:
Wing Span: 28 inch
Length: 28 inch
Weight with no battery: 3.75-4.5 oz (depending on motor & equipment used)
Ready to Fly Weight: 5.5 oz with 460mAh 2S 11.1v Lipo
Center of Gravity
Start with 2” to 2 1/4” from the front leading edge at the wing root. Test fly it then move the battery forward or rearward to suit your needs. The plane should fly hands off in straight level flight both upright and inverted when proper CG is used.
Aileron , Elevator, and Rudder Throws
30 to 45+ degrees deflection for each direction depending on your preference
Dual Rates optional
Expo is at your preference 30% to 50%
needed to build and finish:
Foam Safe / Odorless CA glue + Foam Safe Accelerator
Hot glue
Blenderm Hinge Tape
Sandpaper
Hobby Knife + small square file
Ruler (preferably metal)
required equipment:
4 Channel Transmitter + Micro Receiver
3 Micro Servos (HXT500 or similar)
Micro sized low KV Outrunner (20 grams or under)
ESC: 10Amp or 12Amp, depending on motor used
Prop: GWS 8043 or 8060
Lipo Battery: 360 ~ 460mAh 2S 7.4v up to 3S 11.1 20C up to 45C
recommended set up:
Motor: 2204-14T 19gram 1450kv motor or T-Motor 2202-32 14.5gram 2350kv
